ODL 17069000R Instalační příručka Strana 21

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 63
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 20
21
Caulk Gun
Measuring Tape
Metal Shears
Roofing Sealant
Safety Equipment
Plastic Underlayment
Flashing
TOOLS & PARTS
Draw a horizontal line across the center of the hole in
the roof, running side to side the entire width of the
Formable Flashing.
1
Cut a slit through the METAL ROOF PANEL ONLY
across the horizontal line. Use gloves for safety.
2
With your safety gloves on, be sure your cut is
smooth and free of sharp edges.
3
2
Slide the Plastic Underlayment Flashing through the
slit under the upper metal panel. Then down under
the lower metal panel. Be sure the opening is aligned
with the cut hole.
4
Run a continuous bead of sealant between the
Underlament Flashing and the next layer of roong
around the opening.
5
4
Cut Slit In Roof Panel
Section-12b
Metal Roofing Installation
Plastic Underlayment Flashing fully
inserted underneath metal roof
4
5
Zobrazit stránku 20
1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 62 63

Komentáře k této Příručce

Žádné komentáře